Pi-Lit® Smart Flares self-synchronize; no searching for pre-numbered flares or programming required. It's that easy! Sequential-flashing provides advanced warning and guidance similar to runway landing lights. Drivers slow and change lanes farther in advance when sequential lights are deployed. A compelling economical replacement for traditional flame flares. And much safer to use! 

​

• Available colours Orange Flare, Blue Flare , Red Flare, and Yellow Flare 

• Radio communication 2.4 GHZ (ISM band) 

• Long range 15 metres on the ground and 330 metres on top of a cone

• Built Strong Can withstand 30,000 lbs static load

• IP65 rated Water, snow, dust resistant (can withstand any weather event)

• Working temperature -40°C to 60°C

• Visibility 1000 metres with 360-degree horizontal viewing angle and 180-degree vertical projection

• 2 systems available Rechargeable 1750mAh lithium battery or AA-Alkaline battery system available (24+ hrs Rechargeable, 36+ hrs Alkaline)

• Supplied with Carrying/charging case, 12/24V car charger, wall charger. (Installed AA batteries for Alkaline set)

• RDS™ (Rapid Deployment System) Turn on a flare by simply removing from the case. No buttons needed. (Rechargeable version only)

• Tilt sensor Automatically adjusts light output to top or side flash to enhance brightness and increase warning

• Strong magnetic base To allow mounting on vehicles, signs, cones, etc. Mounting flares on back of vehicle creates an effective/low cost temporary light bar

• 5 flash patterns to choose from 4 sequential, 1 simultaneous

  • Pattern 1 = Single flare march

  • Pattern 2 = Two flare march

  • Pattern 3 = “Wave” pattern (tail off pattern)

  • Pattern 4 = Fast, single flare march (alerting)

  • Pattern 5 = Simultaneous pattern (tail on, tail off)

• Reverse sequential direction Without resetting the system (can be deployed in reverse order)